Pumice's printed body

The body Pumice can move into out in the real world.

Download in colour (3MF)One colour (STL)

With room for its heart (3MF)With room for its heart (STL)

Printing it

  1. For colour, open the 3MF in Bambu Studio or PrusaSlicer. Each colour comes in as its own part, already tinted; if the slicer asks, load it as one object with several parts, then give each part a filament. On a one-colour printer, use the STL. Both are in millimetres and already stand on their base.
  2. Print it upright, with supports for the head and chin. 0.2 mm layers and 15% infill are fine.
  3. Under the base is a round pocket, 27 mm across and 2.2 mm deep. Press a 25 mm NFC tag (NTAG215 sticker or disc) into it, with a drop of glue.
  4. Write the tag below, so a tap on the body moves Pumice in.

With room for its heart

  1. The "room for its heart" files stand Pumice on a taller, hollow base (56 mm across, 21 mm deep inside) with a window at the front, and put a push-in lid beside it. Print the lid lip up.
  2. The base's roof spans the hollow, so turn on supports touching the build plate. Clean them out of the hollow after printing.
  3. The tag goes in the pocket under the lid. Use an "on-metal" NTAG215: the heart's battery sits just above it.
  4. Put the heart in with its light sensor and microphone facing the window, then push the lid in. If the lid is loose, wrap a strip of tape around its lip. See Pumice's hearts to set a heart up.

The model is rebuilt from how Pumice looks right now, including what it wears. Download it again after Pumice changes.